My sad IO

5 replies [Last post]

harry2012

Online Status: Offline
Joined: 05/11/2013
Posts:

Post Date: Tue, 26/11/2013 - 5:46pm

Hope someone here maybe able to help me. I am chasing a senor plate and washer that sits behind the timing pulley on the crankshaft. 1.6 ltr io.

I am unable to buy this part new and have had no luck trying to get 1.

any help welcome

regards Neil

bob_oz

Online Status: Offline
Joined: 31/03/2011
Posts:

Post Number: #1
Post Date: Wed, 27/11/2013 - 11:01am

1.6L sensor and washer

give mitsubishi wreckers a call and put a call otu for a blown 1.6L engine.

they came out in mirages - join some mirage forums or 4Gtuner.com forum and put a "help" post up, you'll find someone with a dead 1.6L block or someone who upgraded to a 2.0L that has one lying around - I have found more parts for my io off lancer forums than here or in wreckers!!

81gl

Online Status: Offline
Joined: 26/10/2013
Posts:

Post Number: #2
Post Date: Mon, 02/12/2013 - 2:09pm

I'm not very familiar with

I'm not very familiar with the iO's, but do have a few Lancer parts laying around in the shed.

If you have a picture to show which type it is I 'may' have one.

bob_oz

Online Status: Offline
Joined: 31/03/2011
Posts:

Post Number: #3
Post Date: Mon, 02/12/2013 - 4:07pm

parts

items 03064 and 03258

harry2012

Online Status: Offline
Joined: 05/11/2013
Posts:

Post Number: #4
Post Date: Mon, 02/12/2013 - 8:22pm

Hi and thanks for the

Hi and thanks for the info.

The parts I am chasing are 03038 03064 3258 I think the 2 pins are part of the pulley but not totaly sure as mine have been sheard off

regards

Neil

bob_oz

Online Status: Offline
Joined: 31/03/2011
Posts:

Post Number: #5
Post Date: Fri, 06/12/2013 - 8:27am

4G15 parts

any proton or lancer with a 4G15 motor will provide these parts.

any pick-n-pay-less wrecker will have one in their yard.

you will need to borrow/rent a cordless impact driver to remove the crank nut OR take in a car battery and spark-plug socket to kick the motor over and use the breaker bar method (see my DIY timing belt post)

gear and plates behind pully come off with gentle crowbaring and some wd40. - i'd expect about an hour total with a motor in part-stripped condition.

Did you find out what caused these pins to shear?

I was at the Wacol u-pullit yesterday and passed two 4G15 motors ripe for the picking

My sad IO

1.6L sensor and washer

I'm not very familiar with

parts

Hi and thanks for the

4G15 parts

Syndicate

Translate This Site Into Your Language