flashing lights

8 replies [Last post]
eddie27
  • Online Status: Offline
  • Joined: 23/12/2012
  • Posts:
  • Post Date: Wed, 16/10/2013 - 8:22pm

sometimes the ligths for four drive  flashing when lam drive can anybody tell me with the problem.

could it be the switch on the t/box

l have just brought a mitsubishi pajero qa 10 1999 model with a 1.8ltrs motor and l would like to known if they any good

Iam wrap in my io

 

Claude io
Claude io's picture
  • Online Status: Offline
  • Joined: 11/10/2011
  • Posts:
  • Post Number: #1
  • Post Date: Wed, 16/10/2013 - 8:47pm
light flashing

While not 100% sure but more than likely a faulty switch. Does the light goes "off" when you apply some light pressure to the T/C gear selector toward the rear of the car ? If it does, chances are that the switch is on his way out.

The T/C have two set of switches, one have 3 switches and the other 2 switches. The set with the two switches have probably one faulty one (sorry I don't remember which one)

While not 100 % sure, I had the same pb on the io I sold, and that was the switch. I even cut open the faulty switch to see the inside, the contactor are so small....

Mitsubishi have them at around $90 each, and if I am right you are the one that mentioned "Amayama" I recently order two of those and a few other bits. If I get them and they are the right one, thanks....$20 each + freight.yes

Happy io

My io is now SOLD Thankshttp://pajerio.com/forum/claudes-io-2002-zr-built-thread-onlyhappy-io 

eddie27
  • Online Status: Offline
  • Joined: 23/12/2012
  • Posts:
  • Post Number: #2
  • Post Date: Wed, 16/10/2013 - 9:04pm
no it when l put my foot down

no

it when l put my foot down a bit hard to get up a hill in two wheel drive it start flashing  but drive on flat road it OK

l have just brought a mitsubishi pajero qa 10 1999 model with a 1.8ltrs motor and l would like to known if they any good

Iam wrap in my io

 

Claude io
Claude io's picture
  • Online Status: Offline
  • Joined: 11/10/2011
  • Posts:
  • Post Number: #3
  • Post Date: Wed, 16/10/2013 - 9:43pm
light

Does it come off as soon as you let go the accelerator ?

I still think that it is a faulty switch, but again, I could be wrong....ask my wife !!

My Io have a similar pb, and it started like you described, then at any acceleration the light do come "on" . I think that the acceleration get something to move (like flex in the engine, gearbox mounts) and put some pressure on the shaft inside the T/C and get that switch to play up. But My light goes off when I move the T/C selector gear as describe above.

I hate these switches !!!

Happy io

My io is now SOLD Thankshttp://pajerio.com/forum/claudes-io-2002-zr-built-thread-onlyhappy-io 

eddie27
  • Online Status: Offline
  • Joined: 23/12/2012
  • Posts:
  • Post Number: #4
  • Post Date: Thu, 17/10/2013 - 2:13pm
what number did you use for

what number did you use for the switch's could you tell me please so l can order them too

l have just brought a mitsubishi pajero qa 10 1999 model with a 1.8ltrs motor and l would like to known if they any good

Iam wrap in my io

 

Claude io
Claude io's picture
  • Online Status: Offline
  • Joined: 11/10/2011
  • Posts:
  • Post Number: #5
  • Post Date: Thu, 17/10/2013 - 4:34pm
light switches ref number

These are the one that I have ordered...I hope that I am right about them being the problem....

Mitsubishi    MR388765    SWITCH    (MC AR) -     22.11 AUD, 1 items
Mitsubishi    MR388764    SWITCH    (MC AR) -     22.11 AUD, 1 items
 

Freight to be added, it was close to $21 but I have ordered a couple more thing too.

Happy io

My io is now SOLD Thankshttp://pajerio.com/forum/claudes-io-2002-zr-built-thread-onlyhappy-io 

eddie27
  • Online Status: Offline
  • Joined: 23/12/2012
  • Posts:
  • Post Number: #6
  • Post Date: Wed, 06/11/2013 - 8:17pm
got the flashing light fix

got the flashing light fix today cost $600.00

new solenoid put in all  OK by mitsubish and a diagnosed done

l have just brought a mitsubishi pajero qa 10 1999 model with a 1.8ltrs motor and l would like to known if they any good

Iam wrap in my io

 

Claude io
Claude io's picture
  • Online Status: Offline
  • Joined: 11/10/2011
  • Posts:
  • Post Number: #7
  • Post Date: Wed, 06/11/2013 - 8:35pm
$$

Bugger...you didn't get away with just the cheaper switches....$600 seems to be a bit expensive for the solenoid, they may have passed a bit of time to sort it out. Is it the part number MR534632 that they replaced ?

Happy io

My io is now SOLD Thankshttp://pajerio.com/forum/claudes-io-2002-zr-built-thread-onlyhappy-io 

eddie27
  • Online Status: Offline
  • Joined: 23/12/2012
  • Posts:
  • Post Number: #8
  • Post Date: Wed, 06/11/2013 - 9:20pm
no mr410724 it say on the

no mr410724 it say on the paper work valve-freewheel clutch control $320

l have just brought a mitsubishi pajero qa 10 1999 model with a 1.8ltrs motor and l would like to known if they any good

Iam wrap in my io

 

Syndicate

Syndicate content

Translate This Site Into Your Language